Français
PLATE AND GASKET EXCHANGERS
These exchangers consist of a set of corrugated and stamped plates following different profiles which, after assembly, form circulation channels for the fluids. The joints ensure, thanks to their shape, the peripheral tightness of each plate and authorize or prohibit the flow of fluids between them. The plate and gasket heat exchanger is therefore a counter-current heat exchanger; it can be a water-to-plate heat exchanger or be used with another more complex fluid. BAS type family from 0.4 to 2000 m² Normal stamping More than 45 plate sizes average stamping depth from 1.5 to 4.4 mm Diameter of connections DN 32 and DN 50 for threaded connections, DN 50 to DN 500 for flange connections. Deep drawn with wide channels (plates designed for slurries) 9 plate sizes average deep drawing from 5 to 11.5 mm (Without contact points between the plates) Diameter of connections DN 32 to DN 300 possibility of special fittings Differential pressure up to 6 bars Double plates (plates designed to prevent any contamination between the 2 fluids) More than 20 plate sizes Connection diameter DN 32 to DN 300
Plate heat exchangers, heat exchangers, process fluids, utilities, energy recovery, waste heat, climate engineering, cogeneration, etc.For each type of exchanger: Threaded male connection Docking on frame with flanges according to standard EN 1092-1 or ANSI B16-5 Calculation pressure up to 25 bar Plate material: AISI 304 – AISI 316 – Titanium Gasket material: Nitrile – EPDM – Viton (clipped or glued) Frame material: carbon steel epoxy paint – stainless steel (food grade)
